3.000m long, Ridge Cap, Galvanised, 190mm x 190mm x 120°
- Buy 14.99 for £24.64 £20.53 each and save 7%
- Buy 29.99 for £23.10 £19.25 each and save 12%
- Buy 49.99 for £21.74 £18.12 each and save 18%
- Buy 74.99 for £20.53 £17.11 each and save 22%
- Buy 99.99 for £19.45 £16.21 each and save 26%
- Buy 124.99 for £18.48 £15.40 each and save 30%
- Buy 149.99 for £17.60 £14.67 each and save 33%
Technical Specifications
- Length - 3.000m
- Dimensions - 190mm x 190mm
- Angle - 120deg
- Finish - Plain Galvanised
- Material - Galvanised Steel
- Thickness - 0.7mm
- Weight - 6.24kg
- Lap - 100mm mimimum
- Edges - Welted
3.000m long, Ridge Cap, Galvanised
- To run along ridge line of roof. Allow minimum of 100mm when overlapping
- Plain Galvanised
- 200mm x 200mm x 120 deg.
- Should be fastened to the crown of sheeting using a 22mm stitcher screw
- 3.000m long
- 120 degree bend ideal for 30 degree pitch but can adjust to meet similar pitches
- Welted edges
- Lightweight & easy to handle
- Easy to install
- Suit our galvanised steel sheets
- Welted for extra rigidity
How much should I lap the ridges over one another?
You should have a minimum of 150mm for lapping the ridges.
Do I just fix it down with the top run of main fixings?
No, you want to use the stitchers screws to stitch the ridge to the highest point of the profile on the sheet.
How do I know what angle ridge cap I need?
To work out the ridge angle, you will need to work out the angle of each slope (commonly the same each side on apex buildings). You then minus the two angles from 180° degrees to give you the angle of ridge you need. E.g. if you have an equal apex roof with 30° it would be 180° - (30° + 30°) = 120°.
Is there any flexibility in the ridge flashing?
There is a small amount of flexibility in the ridge, so if you are using our 120° stock ridge you will be able to flex it some degrees either way.
Can I get different sized flashings?
Yes, we can manufacture made to order flashings. If you want to make an enquiry, please contact our sales team.
Can Southern Sheeting cut flashings?
Southern Sheeting will not cut stock flashings. Made to order flashings can be cut to different lengths and girths.
Find the right materials and support for your project
We can help! View our supportive help guides and videos.
Our supportive guides and help videos will help you achieve the best results. Our knowledgeable team can also offer helpful tips, and support to help you plan and purchase what you need!